The Line Count Limits box on the Interface tab:

is used to control the total number of output lines that can be stored in the command window.

When LINGO sends output to the command window, it places it at the bottom of the window. All previous output is scrolled up to make way for the new output. The Maximum field sets the maximum number of output lines allowed in the command window. When LINGO hits this limit, it starts removing lines from the top of the command window until there are n lines left, where n is the value of the Minimum field.

In general, output to the command window will become slower as the maximum and minimum line counts are increased, or the difference between the maximum and minimum is decreased. If you have a long session you need to save, you can use the File|Log Output command to log all command window output to disk.

The default value for Line Count Limits is 800 lines maximum and 400 lines minimum.